Differences

This shows you the differences between two versions of the page.

--- home_automation [2026/08/06 15:30] – old revision restored (2026/07/26 17:02) w5ged
+++ home_automation [2026/08/13 15:17] (current) – w5ged
@@ Line 1: / Line 1: @@
 ====== Home Automation System ======
-I'm using [[https://www.home-assistant.io/|Home Assistant]] running on a [[https://www.raspberrypi.com/|Raspberry Pi]] 4.
+I'm using [[https://www.home-assistant.io/|Home Assistant]] running in a Proxmox Virtual Machine.
 Whenever possible, I use WiFi to communicate with remote devices.
@@ Line 44: / Line 44: @@
   * [[https://store.rakwireless.com/products/wisblock-meshtastic-starter-kit?variant=41433735758022|RAK WisBlock]] - aka: with u-blox ZOE-M8Q, OLED Display & solar enclosure
-Tasmota Rules:
+====Sample Tasmota device====
-  * Control a remote switch based upon a local temperature value with fire alarm override
   GPIO1    Switch1   Fire alarm contact closure input
+  GPIO2    Relay1    Contact closure output
   GPIO7    AM2301    HVAC Supply Temperature/Humidity
   GPIO43   Buzzer    Buzzer
   GPIO44   AM2301    Free Air Temperature/Humidity
-  SwitchMode1 2 (GPIO pin is pulled low when the fire alarm is active)
+The XIAO-ESP32S3 devices use firmware: tasmota32s3.bin with the template configuration:
+  {"NAME":"GED-ESP32S3","ARCH":"ESP32S3","GPIO":[32,1,1,1,1,1,1,1,1,1,0,0,0,0,0,0,0,0,0,0,0,544,0,0,0,0,0,0,0,0,0,0,1,1,0,0,0,0],"FLAG":0,"BASE":1}
-  Rule1
+Devices can be configured by browsing to their IP address & going to Tools/Console.
+  Tasmota settings:
+  Setoption8 On (Output temperature in °F)
+  Teleperiod 60 (Report to MQTT server every 60 seconds)
+  SwitchMode1 2 (when the GPIO pin is pulled low during a contact closure it reports "ON")
+  Rule1    Relay state follows the contact closure state
+  ON Switch1#State DO Power1 %value% ENDON
+  Rule2    Sound the buzzer then a contact closure is detected
   ON Switch1#State=1 DO Buzzer 1,5,1 ENDON
-  Rule2
+  Rule3    Control a spot cooler based upon two temperature sensors
   ON Switch1#State=1 DO WebSend [192.168.10.170] Power1 0 BREAK
   ON Tele-AM2301-07#Temperature>80 do WebSend [192.168.10.170] Power1 1 BREAK
   ON Tele-AM2301-44#Temperature<80 do WebSend [192.168.10.170] Power1 0 ENDON
-===== Tasmota Sensors =====
-I like to use [[https://wiki.seeedstudio.com/xiao_esp32s3_getting_started/|Seeed Studio XIAO ESP32S3 Development Board]] running [[https://tasmota.github.io/docs/}|Tasmota]] firmware.
-  * D04 BME280 SDA
-  * D05 BME280 SCL
-  * D08 DHT22
-  * D09 DS18B20
-  * D10 Buzzer