I'm using Home Assistant running on a Raspberry Pi 3. Whenever possible, I use WiFi to communicate between remote devices.

Integrations include:

• Kodi (Media Center)
• Konnected Alarm Panel Pro (12-Zone)
• MQTT
• Obihai (Home Telephone)
• Shark IQ (Vacuum cleaner)
• Tasmota (Lights, ESP32 devices, Temperature sensors)
• UniFi Network (Network & WiFi access points)
• UniFi Protect (Video cameras)
• QuinLED-Dig-Quad with WLED firmware
• Gledopto WLED Digital Light Strip Controller
• SMLight SLZB-06M Ethernet/WiFi PoE Zigbee Adapter
• RATGDO Garage Door Opener

The following hardware has been flashed with Tasmota & connected to Home Assistant using MQTT:

• Kauf A15, A19 & A21 Bulbs
• Seeed Studio XIAO ESP32C3 Development Board - Don't use these (no longer supported)
• Seeed Studio XIAO ESP32S3 Development Board
• Sonoff Pow R2 Power Monitoring Switch Module
• Sonoff S31 - Used to monitor power consumption & control outlets
• Sonoff Slampher R2 - Table lamp
• Sonoff THR320D - Used to monitor temperature/humidity and control an attic exhaust fan
• Sonoff TX T0US3C - Wall switch used to control 3 devices
• Sonoff NSPanel Touch Display Switch - Wall switch and display
• Unexpected Maker TinyS3 ESP32-S3 Development Board

Sensors

• Analog Devices DS18B20
• DHT22 - Do not use with a Raspberry Pi
• Bosch BME280
• Bosch BMP280

Network Infrastructure:

• LilyGo ESP32-S3 LoRa Development Board with SX1262 868/915MHz GPS U-blox L76K - aka: T-BeamSUPREME (M)
• RAK WisBlock - aka: with u-blox ZOE-M8Q, OLED Display & solar enclosure